|
|
|
               
|
|
 | |  | | | Eswa Limitedunderfloor heating london, underfloor heating installers london, underfloor heating london, heating south london, heating north london, heating east london, heating west london, | | | Company | Eswa Limited | | | Contact | Mr Robert Scriven | | Address | 32 Monkton St
London
England UK
SE11 4TX (MAP)
| | Telephone | 02075 824 300 | | | Fax | 02077351 456 | | Email | | | Website | www.eswa.co.uk | | | ESWA offers a choice of low temperature radiant ceiling heating panels, underfloor heating cables and under-tile mats that can be used independently or together to provide a clean, comfortable, safe, silent and maintenance-free heating system. The system offers comfortable, gentle all-round heat, obstruction-free room layouts and economical running and installation costs.
The company has over 50 years experience in the design and installation of low temperature radiant heating systems in all types of buildings in the UK.
The systems have been installed and are in use worldwide in all types of building and in all climates. Of particular benefit in residential dwellings, the ESWA systems have also been installed in offices, health centres, clinics, mental health units and residential nursing homes.
DESCRIPTION
The ESWA systems provide an even, comfortable warmth throughout the room with no hot spots or cold areas. As the systems utilize large surface areas, the heating elements use a relatively low watt density and operate at only a few degrees above ambient temperature. This ensures that the room's air remains fresh and untainted by carbonized dust, with no feeling of dryness. If installed as an 'Up and Under' floor and ceiling heating system the bulk of the heat requirement can be taken during the off peak hours. However with modern standards of building insulation, ceiling heating or floor heating alone can also provide an economical solution for heating most buildings especially when combined with timed control systems.
Composition & Manufacture
Ceiling heating elements are in sheet form and comprise an electrically conductive foil laminated between 2 layers of protective plastic. They are hermetically sealed, moisture-proof and insulated against electrical leakage. In the event of physical damage the ceiling heating elements are designed to safely fuse within the plastic insulation. Ceiling heating foils are fitted above the ceiling board, fixed between the joists or the MF grid. Control is usually via individual room thermostats to maintain an even room temperature; it can be further enhanced by using setback systems in conjunction with manual override switches or time clocks and zone controls.
Underfloor heating is normally provided by utilising Nexan's electrical floor heating cables embedded in a floor screed, of different thicknesses depending on whether it is to be used as storage or direct acting heating. The cables are fully insulated by a non-hygroscopic and temperature resistant material and covered by an external sheath of PVC. Cables for “wet areas” have a full metal sheath and a separate earth wire, to enable connection to the equipotential bonding, ensuring full compliance with BSI/IEE wiring regulations.
Cables are laid in parallel runs on the entire floor below the screed and the floor finish.
Floor heating is compatible with most floor finishes: timber, tiles, stone, carpet etc. Control is either by a weather sensing storage heating controller or by individual room thermostats.
For “dry floor” constructions where there is no screed ESWA Ltd, is able to offer two solutions: Millimat and ESWA Floor Foils. The Millimat is suitable for installation under tiled or stone floors either on a concrete sub floor or, on a suitable incombustible layer with chipboard or timber on joisted floors. The ESWA floor foils are for use within joisted or battened timber floors with parquet or laminate floors.
SERVICES
ESWA Ltd provide a full design service from CAD or drawings and can provide an installation service if required. Full drawings, case histories and proposals are available from the company. | | | Products and Services | | Eswa Limited is a SelfBuild supplier | | Under Floor Heating | | Underfloor Heating Manufacturers | | | Regions Serviced | | England - London | |
|
| | |  | | |
| | |
| |
|
               
|
|
|
|
| Flagship Media Group LtdUnit C3, 6 Westbank Drive, Belfast, BT3 9LA, Northern Ireland Tel (+44) 28 9031 9008 Contact : Click here |
keycons003 / keycons003xLIS / keycons003x21 24/05/2012 19:30:45 / A9 / B9 / 0.046875, 38.107.179.230
underfloor heating london, underfloor heating installers london, underfloor heating london, heating south london, heating north london, heating east london, heating west london,
underfloor heating london, underfloor heating installers london, underfloor heating london, heating south london, heating north london, heating east london, heating west london,
|
